I really like the install. I'm very interested in the dimming switch. How exactly did you set that up? Did you have to splice into a wire or is it in line? If you don't mind I'd actually like to take this idea from you and apply it to my vehicle.
I removed the 470 Ohm resistor attached to the power LED inside the smartcord and wired the resistors in right off the switch and attached the leads into the smartcord PCB itself. Basically made a wiring harness as the smartcord box is awfully tight to mount a switch.Originally Posted by PWRDbyTRD
Here is a link where I posted the modified schematic:
Good looking install LordVector. I'm sure that you'll enjoy it. No annoying cords.
Maybe we should start a "post pix of your installation thread"? We could maybe get one of the lovely moderators to sticky it?