Beltronics Laserpro 904 display wiring

[KustomEagle]

Anyeone have a wiring diagram or detailed pix of the wire that goes from the control unit to the display head?

[svtcobra]

wow...someone else who still has a laserpro 904...I'm not sure what you're looking for...I might have that though I still have the box to mine lying around somewhere.

I think the 904 is pretty much the same as the 905 which is also supposed to be the same as the escort zr3, which is why I still think this thing is a good laser jammer. I've been using mine for 4+ years now with great results...

Let me know what you want and I'll try to help out. As far as I can remember, the head unit has the 2 wires, one is for power, the other goes to the heads...and there should also be a smaller plastic piece in the middle somewhere...I'll check it out on my car today and see. It really shouldn't be too difficult as long as you have all the necessary pieces. ACTUALLY, I just remembered it's on their website...

Check it out
http://www.beltronics.com/manuals/lp904install.pdf

[KustomEagle]

yea i've got all that; i was looking for the pinout/order/colors of the wire that went between the junction box and the head unit... but i think i figured it out... belscort was nice enought to make everything go in order or at least it looks like it...

but the 904 i got looks like the voltage regulator burnt out...


u still have any of your 904 stuff? like the head unit... if it works and you're not using it i'll buy it off u!!! same if you have any heads working or not!

[svtcobra]

I'd sell it but it's still working in my car so I figure I may as well leave it...

[zr1]

Originally Posted by KustomEagle

yea i've got all that; i was looking for the pinout/order/colors of the wire that went between the junction box and the head unit... but i think i figured it out... belscort was nice enought to make everything go in order or at least it looks like it...

What pinout diagram have you got worked out so far?

[KustomEagle]

Originally Posted by zr1

What pinout diagram have you got worked out so far?

if u open up the interface module and the display it goes from pin 1-8 in order; power/gnd/extra gnd/datax5

its pretty obvious on the 904

now if only i could figure out the voltge of the f'ing zr3s use... the voltage regulator in the 904 is fried and so is my srx :-/