Howdy all, I would have posted this direct to a RX75 user, but since I'm new here I can't do PMs. Hopefully someone can help me getting my RD going again.
I have an old RX75 sitting in a box which I recovered from a car of mine which met an early death a couple of years ago. As the car was written off by the insurance company I decided I wanted to take my RX75 out of it before it went to the scrap heap (somehow, despite the accident, the RX75 survived), but as the installation was very tight (and there were cable ties every 30cm) I ended up having to cut the cords to get it out. At the time I didn't think this would be an issue as I thought they were standard telephone type cords. Putting it back together, however, was not as simple as I didn't check pin orientation etc before cutting, and left the plugs behind for some unknown reason.
I tried to do this a while back via another forum but the person only described the wire colours and pins to me, and there was confusion over the plug orientation. I tried a few different combinations, but it behaved rather oddly and didn't work. With any luck I didn't fry it.
So I was hoping someone might be able to take some pictures of each plug which goes into the hub (ie: the radar antenna, the laser receivers and the control panel) so I can see what coloured wire goes to what pins. (eg: hxxp://upload.wikimedia.org/wikipedia/commons/thumb/a/a6/RJ9_Handset_diagram.svg/1000px-RJ9_Handset_diagram.svg.png)
It would be greatly appreciated, as I'd really like to get my RX75 going again, it was only about a month old before the accident ...
Thanks in advance