I have find out that STi Magnum ~ poor sensitivity or reaction against both my ( RX65 A /RX65 I ) in all band ~
Even if I turn all band off ~ and only testing 1 band at a time ~ result is the same !
While BELscort are said & listed that : " firmware update can be OTA for Bel STi via The Escort Live cord "
But while I ring them up last night ~ the answer is no ! From one the guys for Bel's ~ Pls verify if true !!
I have been try to see & check the software version < but by reset it like the RX65 > would not show u the soft. Version at all ~
By all I have try to find out about possible update ~ I have also disassembling it
I have test on it ~.
This is what I found ~
1) The STi magnum - have reception gain while case off
It is that there is no different if it is completely off ~
or just leave a 1mm gap in between top & bottom case ~
Result is a 1-2 bar(s) signal gain ~!!!
No sure if it is because the Magnesium case causing the trouble
Protect the interfere from the outside ~
But may as well also trap & echo its own interference on the inside ~ " Guessing"
That why leave a small gap would help the echo out ~ some like that ~
Any one have try this before?? Pls reply & share what u Find ~
2) notice ten pin where u can see thro the speaker vent "Uart ?" <- any Atmega32 expert pls kindly advise us !