My Blinder M20 is on it's way and I am seeking some opinions on mounting locations.
There is little room behind the upper hood mounted grill, and there is no way to cut that mesh and still retain a clean inconspicuous look. The lower left and right grills, which incorporate the fog lights, are infront of dual side mounted intercoolers so it would be detrimental to mount them there.
So the lower center grill area is the remaining location. There are two grills seperated by the horizontal bar. I haven't measured yet, but that bar appears to be a bit greater the 13mm which is, I believe, the dimension of the receiver/transmitter. Looking at the front lower center grill, I could mount them under the top edge of the upper opening, just below the space where the euro front bumper would go. They chould be flush mounted up high and under the bumper edge. This would probably the least noticable from any angle other then straight on and close to the ground especially if I set them back an inch or two.
I could mount them in the lowest location along the very bottom edge of that grill mesh but I think from in front of the car they would be very visible..
Or, I could notch the horizontal center bar and set them in the bar...alot of work and I think it would interrupt the flow of the horizontal bar.
So I am thinking the first option is best...
* How would this be for performance assuming I notch out the cross-hatch mesh so the front of the units are unobstructed?
* Are they too low?
* Is this far enough apart??
I will use the Blinder in conjunction with a V1 with a custom install. I have read as much as I could find about Veil, and although it seems like a perfect combination (Veil, V1 & Blinder) I am not prepared to smoke/tint my headlights in any way...so that is not in the plan at this time.
Thanks in advance!!