WIRING QUESTION

**jimntex** · 08-20-2006, 04:56 PM

I have a M40 for the front and a M20 for the rear. I was wondering if I can use one sitch to control the power source so they can be both be activated/deactivated at the same time? I also have found a LED lit switchthat would make this switch eazy to activate/deactivate in low light. Will this illuminated round rocker switchswitch work?
http://www.wiringproducts.com/?target=dept_11.html

**jdreynss** · 08-20-2006, 05:06 PM

Originally Posted by jimntex

I have a M40 for the front and a M20 for the rear. I was wondering if I can use one sitch to control the power source so they can be both be activated/deactivated at the same time? I also have found a LED lit switchthat would make this switch eazy to activate/deactivate in low light. Will this illuminated round rocker switchswitch work?
http://www.wiringproducts.com/?target=dept_11.html

You should be able to use any standard rocker switch. The blinders run off of 12vdc, so it should be fine, just make sure to use the proper rated fuse, refer to your owners manual for fuse rating