I was watching a video by Cheetah about their wireless Blinder installation kit and i was wondering what about the two back heads for the laser?
How will these be connected to the battery for power? I am assuming that they need to be connected to some sort of power. Do you need to run wires from them through inside the car to the front at the battery.
Also, they were mentioning in video that this is good for swapping between cars but if the heads are mounted by a bracket with screws, then how will they be easily swapped?
Is that assuming that we need to buy an extra set of heads for the 2nd vehicle and just swap the wireless install kit?
About the heads also, can they be installed with a strong 3m sticker or do they have to be drilled with the brackets for them?