Hello all. New member here.
I have searched and searched but have not yet found a solution to my problems.
Here is my setup:
8500 x50 Red hardwired into Honda S2000
I have the meter on expert with X turned off and always run highway mode
Here is my problem:
When the detector is cold and not at operating temp (I assume) it will full alert K, Ka, and X (enabled to check this band also). These alerts stay at full blast for at least 10 minutes. Usually I get so aggravated that I turn the thing off and wont turn it back on again until I am out of work. At which point it starts up and works fine after sitting in the warm air all day.
Things I have tried
Switching cars - did not work
Using OEM cig cord - did not work
Keeping detector in house overnight - did work but annoying and not solution I want.
Also, sometimes during full alerts a red circle or dot will flash in the upper right hand corner of the display, what is this? I have read on here about Rev's as well, how do I find out which rev I have?
The unit was purchased from Best Buy in May 07.
Thanks in advance!
-Mike
Bookmarks