Does anyone know if this will stick over the black dots above the RVM? It looks pretty heavy duty, just wondering if anyone has tried.
Does anyone know if this will stick over the black dots above the RVM? It looks pretty heavy duty, just wondering if anyone has tried.
Nope mine fell off when I tried and that was before I put the rd on it.
Mine does hold firmly but the dots only cover the top 30% of the suction cup, the windshield covers the lower portion or roughly 70%.
I would not mount any suction cup over the ceramic dots. It just asking for it to fall off. If you need to mount over the ceramic dots (like I did) modify your stock RD mount. I myself use "superlock fasteners" I purchased this at RadioShack. I copied it from this http://www.radardetector.net/forums/...-your-rvm.html
I used this for a while but it fell apart after a month of use. That was with two hours of use per day. Poor quality. I replaced it with the BlendMount. So far it is much more stable.
There was a similar post on the Valentine section a short while ago - solution was to use thick shipping tape over dots to make a flat surface.
http://www.radardetector.net/forums/...tion-cups.html
2010 Honda Civic Sedan
Cobra 19 DX IV CB
Wilson Lil Wil
Uniden BCT15X Scanner
Garmin Nuvi 1300
Saves: More than I can count
I just use the stock mount and leave it under my RVM. Not enough room above it and if I mount it above and to the left it points left instead of straight.
Bookmarks