Hello everyone,
I was replacing the speaker on my silver X50 when I accidentally chipped a few resistors off of the PCB board (I know, very careless). Now I need to find out what the specs of the resistors are so I can replace them.
I need someone with an X50 to open up the case and take a close up picture of the area in question. The X50 needs to be silver model with S7 horn (not M4 - that has a different board). The value on the back of the resistors needs to be visible within the picture (I was able to get it with my 5mp smartphone and the following frame).
If you are unsure of your horn type, an FCCID ending in M4 indicates an M4 horn. S7 should be something else, but I'm not sure since my sticker is torn off. Also, an S7 should look like this with the case off:
2013-01-02004035_zps6bdbcaec.jpg
2013-01-02002942_zpsd82478af.jpg
Here is the general area (3 resistors fall within the red circle):
Board_zps8c64bf18.jpg
And here is a zoomed in version of the same picture. Circled are the nubs that used to be connected by resistors:
close-up_zpsdc1a521a.jpg
If anyone could do this for me, it would only take a few minutes, but would be a HUGE help.
Thanks!
-CJ
Bookmarks