Results 1 to 3 of 3
  1. #1

    Default LI control box location

    As you can see, CB is located right next to my vent. Should I worry about moisture build-up when bi-level AC is on? Also, will heater also affect the control box?

  2. #2
    Rocket Driver
    Join Date
    Jun 2008

    Default Re: LI control box location

    I doubt it will be a problem, if heat is blowing directly on it from the vent then it may cause problems with heat buildup. But unless it is blowing directly on the control module I think you should be fine.

    If it's just sitting on next to the vent and you are worried, cut you a thin piece of styrofoam to go between the control module and vent to provide insulation.
    Valentine One (3.858 Ice Cream Truck, 3.812 in Vette)
    4 Head LI (On Vette) (7.11 CPU Regular heads front, HP Heads on the rear)
    9500ci (On Vette)

    LI Quad (On Ice Cream Truck)

    LI Dual (On SRX, 7.06 CPU)

    ProLaser II, ProLaser III, Stalker LZ-1, LTI Marksman & Laser Atlanta "R" (looking for an Ultralyte LRB)

    2008 Corvette Z-51 Coupe

    Escort 9500 ix (Cadillac SRX)

  3. #3
    Power User
    Join Date
    Nov 2007

    Default Re: LI control box location

    You can use superlock strips to attach it somewhere else...



Similar Threads

  1. LPP Updated Control Box for TS
    By samq45 in forum Laser Jammers - General
    Replies: 27
    Last Post: 07-08-2009, 10:05 PM
  2. Drive Control Pro
    By nickstath in forum Radar Detectors - General
    Replies: 7
    Last Post: 01-12-2009, 07:44 AM
  3. quality control on pro 78
    By Ck15 in forum Whistler
    Replies: 3
    Last Post: 06-29-2008, 12:35 PM
  4. Quality control?
    By METEORIC in forum Beltronics
    Replies: 10
    Last Post: 10-23-2007, 01:23 PM
  5. Control nob is losing on new V1
    By theblackv in forum Valentine One
    Replies: 18
    Last Post: 10-14-2007, 10:05 PM


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts