So a smidge under half an inch difference then? I'll need 1/2 inch shims if I upgrade my heads then, or completely re-engineer my in-grill mounting scheme...
So a smidge under half an inch difference then? I'll need 1/2 inch shims if I upgrade my heads then, or completely re-engineer my in-grill mounting scheme...
If I'm passing you on the right, YOU are in the wrong lane!
If speed kills, how come I'm still alive?
Active Countermeasures: V1 3.858, Escort Redline, Beltronics STi-R+, LI Dual 7.1x CPU/8.7 Heads (front)
Other/Backup Countermeasures: V1 3.813 (loaned to friend), Beltronics Pro RX65 M4 6.3
Vehicle: 2002 Audi A4 1.8T Quattro
LEO Toys: Kustom Pro Laser II & III
Encounters/Saves August 2011: Radar 3/1, Laser 0/0
Ok, So what changes have there been since 8.7.
Also, is there some way to be notified of firmware updates other than checking the web site?
Thanks
New Updates to address new LIDARS.
Because many change their email address often, the best way to see if an update is available is to add the update page to your favorites and check in once a month.
Cliff
What is in the update? I have to buy an old school connector so I can update.
It adds new LIDARS.
Cables are available at Radio Shack and on Amazon.
Cliff
Just an FYI to everyone. The new firmware 8.15 is out.
Generation 8 CPU Firmware Released 12 April 2014 Ver. 8.15
https://www.laser-interceptorusa.com/downloads
Yes it is.
However,depending on where you drive in the USA...you may still not have 100% protection from some Lidar models.Just an FYI to let you know.
Yes it is.
However,depending on where you drive in the USA...you may still not have 100% protection from some Lidar models.Just an FYI to let you know.
Bookmarks