I wondered if I did this wrong.
I have a different switch to put in my car because it would fit the slot. I ordered this switch here:
So I made sure that I had power, ground and the accessory correct on the switch. Found the same on the switch that came with the LI but here's where it went strange.
I hooked up the new switch, when I flick the switch, the switch LED blinks, and I hear the LI. The LED will blink like crazy is when I test the LI with my cablevision remote. Then light stops blinking.
The main question here is should the LED be fully lit at all times? I know it will blink when it gets alerted but just wondering. The original switch from LI had 2 other poles on the switch where I have no clue what it does. Thoughts?