I got my Laser Interceptor from the post office yesterday. Cliff sent it very fast, but it had to be signed for and I am never home. I need some suggestions on where to install. This will just be temporary install, until I can get it tested. My previous install of the ZR3 had one head sitting ontop of the bumper and directly under both headlights, the rear head on the front license plate, and it was JTG against the Laser Atlanta. Note, this photo is not my actual car. Mine is black.
One thing that did concern me was the User Guide included with the LI. It is riddled with grammatical errors. This comes as a shock to me, because I have read some of Cliff’s forum post before, and have traded a few emails with him. And Cliff has always been quite eloquent. If I were a consumer, buying an LI on a whim, and I hadn’t personally aimed a Laser Atlanta at Samq45’s LI equipped car, and watched as it JTG, I might instill some doubt in me. I am assuming that Cliff didn’t write the user guide, or maybe that LI is European made and the guide was translated poorly. In either case, I am an engineer, and if I turned in an operator’s manual like that everyone would think I am an idiot.
Cliff, if you like, you can send either a PDF or Word Doc of the User Manual and I will edit it for free. Not only could I fix the grammar, but I could give it some much needed sexiness when you read it too. I feel a well written operator's manual would suite such a well engineered device!
Bookmarks