I currently have m27 jammers and they jam everything but 2 guns currently. (laser ally and prolaser4) . the main reason im seeing about switching to Li is there has been no update for the 7 series as promised upon purchase. im wondering if this will happen again on the hp model.
main reason is i dont like the mounting option im seeing. the sensors are so small on blinder im concerned about mountin as i had to use zipties to get my m27 right level dead on straight. but the hp905 model im not seeing anywhere to affix zipties if i needed to mount this way again. 3m tape is great but not on my chevey grille. its too small and will bank uneven so zipties worked perfectly on m27.
i see Li has holes on both sides of jammers and can def. switch the jammer out with the same approx look as my current jammers with little to no problem. The Li has holes to affix if 3m or the brackets arent an option. I also like the Li has a led and an alarm where the new blinder hp has only the speaker and no led and all is connected to cpu which then has to be positioned to be able to see the cpu module so you can hear it. I also see a switch to kill the jammers on the Li and I am not sure on this one with blinder. i would think it would have a 3 way switch as well like their 7 seies to go from parking mode to jam mode, etc.
anyone with any help on these 2 jammers for replacement on my current blinder m27, please contact me or respond here. I just find it all comes down to the mounting questions, and the cpu with no led on blinder(is this a problem) not being able to visually see a led when set off and positioning of the cpu so you can hear the alarm when it goes off. anyways, trying to figure this stuff out before i drop 5 bills on a dual. thanx