i bought one week ago a bel rx65...
and i'm just to have some information about the compatible laser jammer LaserPro 905...
any opinion about that?
tnx a lot...
i bought one week ago a bel rx65...
and i'm just to have some information about the compatible laser jammer LaserPro 905...
any opinion about that?
tnx a lot...
dont know much but;
Features
Unique "shifting" system virtually eliminates laser speed measurement
Alerts to Laser encounters from front and rear
2 discreet exterior-mounted front Laser modules
1 rear-mounted Laser module
Direct connection with BEL’s Vector and Pro series detectors
Fully integrated detection / defense system
Loss of connection alert when Laser modules are not properly connected
Set includes 1 rear exterior-mounted laser transceiver, 2 discreet exterior-mounted front laser transceivers, and a central hub for easy connection of all components
tnx a lot for the feature...
p.s.
i'm from italy...
All I have to say is put the rear transponder on the front of your car as well. The rear transponder isn't powerful enough to jam laser from the back. Might as well put it in the front for some good use.
Chris
:P :P a great opinion...Originally Posted by JammerTests Webmaster
do you know how are connected the trasponder? with cambles or others??
tnx a lot
do anyone know if it's difficult to mount it om my car ( an audi a3 '01)
tnx a lot!!
stefano
One thing to remember is that this system requires the RX65, RX55, Vector 995, or Vector 965 in order to work. It is not a stand-alone unit. If the detector goes bad then the system is useless until you get another compatible detector from Bel. There are also no replaceable lenses so if they get scratched up or broken you are SOL without buying a complete replacement head. People have also reported that their units leaked water after the warranty was gone causing them to go bad. Also if you do not buy from an authorized retailer or get the unit installed professionally then you have no warranty on it either. If something goes bad then you still may have to pay for an installer to remove and replace part of the unit. For these reasons and after comparing it to some other laser jammers, I decided not to get it even though I have an RX65.
As far an installation, post a picture of your car. You also need to plan out where you will run the wires to get through your car's firewall and get power. You also need to find a suitable location for the central hub and figure out how you will connect to your detector.
all easy, just follow the other cables and use a tracer...
Why do you need a detector as well?? Is this the case for the Bllinder and mimic?? How does it work with the jammer??
Also the hooking thew BEL LP905 to the BEL unit makes the BEL unit activate the jammers making it act like another reciever
Spoiler: show
oh ok....I see so the blinder and mimic work alone..
Bookmarks