Hey guys, looking for some input on placement for a dual-head laser. Front of car is as follows (apologies for the glare and difficult to see picture)
Car is black and currently does not have a front license plate. It is required, but going to go with no license plate until I absolutely have to.
Without a front license plate, I'm pretty sure the aim is going to be front headlights with a possibility of the front grill as well. It appears there are three choices to mount the two heads -
Front grill - advantage is that it is at grill and headlight level. Disadvantage is that it is the most difficult to mount in there as it comes up with the hood and needs to clear the radiator and a few other things in front.
Mesh area underneath the grill - one on each side. A little lower than the front headlights but central. Advantage is that there is a shelf in the middle of the mesh which would make installing any heads there simple without any brackets and a bit less noticeable than in the chrome grill.
Side grills - Pro is that its located beneath the headlights (but not below the center) and not noticeable at all. Disadvantage - perhaps too far wide ? and a bit more tight in space in there for installation.
Any thoughts as to where would be the best locations dual head setup ? Probably going with a LPP OR AL8 configuration as VA uses PL3 and Stalker and those two appear to be well suited for that.
Anyhow, looking for some input on where you guys think would be the best location on the car.