Antilaser G8 and wireless kit speedcheetah

[radarroger01]

I have connected an antilaser G8 with a GPS-Mirror (speedcheetah).
Its the wireless fitting kit from speedcheetah. My question is, can i programmend the antilaser, such as the "laser interference defense (LID) adjustment" time with the speedcheetah LASERnode connector cable? There is a LED and little cables on the end of this cable.
Which functions have this cable?
Thanks and here is a video of a laser detection "Poliscanspeed in Germany", detection range 290m (bel sti-r and antilaser G8 with a speedcheetah GPS-Mirror)

YouTube - bel sti-r/AL G8(with speedcheetah) vs Poliscanspeed (290m)

Best regards radarroger

[RacerX]

actually what you would do is unplug our cord from the control box, plug in the original AL loom, and then power up the system and use the on/off switch and mute button to program the AL, then shut it down when you are done and plug our cord back into the control box.

you don't need to unplug or disconnect anything else.

[radarroger01]

actually what you would do is unplug our cord from the control box, plug in the original AL loom, and then power up the system and use the on/off switch and mute button to program the AL, then shut it down when you are done and plug our cord back into the control box.

you don't need to unplug or disconnect anything else.

At the end of the original cable of wireless kit are many wires in blue in white and a LED! What for are these thinks?
Thanks and best regards

[RacerX]

the LED let's you see the kit is powered up.
the other wires are not used, since we don't use hte mute button or switch on our loom.