How to UN-Mute the V1

I'll have to say that the Instruction book that comes with the V1 leaves a lot to be desired. THANK GOD for this forum.....

Once I push the button to mute the V1, how can I UN-mute it ?

Is it possible, or will it Un-mute when it resets and goes back to the main Program mode ( Which in my case, is still set to "A") ?

And I don't know about the rest of y9ou, I have a heck of a time trying to read the programming instructions on the Valentine site. They are kind of blurry and small. Is there a link to anything that has a better pdf file of those instructions ?

Thanks, Tim

The V1 will automatically unmute itself when it detects another alert or tha alert is no longer active.

Quote:

---

Originally Posted by boomerman

The V1 will automatically unmute itself when it detects another alert or tha alert is no longer active.

---

But is there a way to unmute it without waiting until the alert is over ?

And. while I'm asking questions...

Tim

There is no way to manually unmute, except for turning the unit off and then back on again. There are some situations where it would be great to have the ability to unmute it (maybe with an additional tap of the mute button?)

Quote:

---

Originally Posted by jimbonzzz

There is no way to manually unmute, except for turning the unit off and then back on again. There are some situations where it would be great to have the ability to unmute it (maybe with an additional tap of the mute button?)

---

I would have thought that would be already the case, guess not then.

Quote:

---

Originally Posted by pratzert

And I don't know about the rest of you, I have a heck of a time trying to read the programming instructions on the Valentine site. They are kind of blurry and small. Is there a link to anything that has a better pdf file of those instructions ?

Thanks, Tim

---

I had the same problem. I found if I printed it in color is was better to read.

Knothole

If you loose a signal while the V1 is muted the reset time is ten seconds.
In other words if a signal is muted manually in (A) mode and you loose the signal, if it comes back within nine seconds the signal will stay muted.
Going through the modes and ending up at (A) again also brings back regular volume.
Also like Jim said to get the V1 to reset manually during muting or any other event, turn V1 off or cut the power, then back on.

Just turn up the mute volume leave for a few moments until you are past the area that you want unmuted.

Just cycle through the modes by holding the mute button down until you get back to the one you want. As soon as you switch over to another mode, all mutes are reset.

/russ