doing my hardwire this second. i need help

[xxbillay]

so im doing my x50 hardwire now, but ihave a few questions. first im going to be tapping into the fusebox, which is the ebst fuse to run it off. sedcond. how would i go about getting my headliner down so i can run the cord though it? any help is appreciated.

if you want AIM on xxbillay cause ill be out in the garage for a little while

[spider_55]

Fuse: 15 A - cig lighter. Use a fuse tap-in from RadioShack or walmart.

Tap into your fuse, or go after your cig lighter wire under your shifter. If you want to know how to safely remove your internal panels, let me know, and I can walk you through it.

Run the wire from the fuse up to where your side air vent is. I taped my wire to a thin / cheap coat hanger and pushed it up to the right, front side of the pillar. Basically push up and left and it will pop between the side plastic piece and the dash in front of the a-pillar. Hard to explain. I can post pics if necessary.

Push the wire into the dash, then begin pushing it into the edge of the pillar. I used an old phone card and a small flat screw driver with electrical tape on it. You do not need to take apart the a-pillar or head liner.

If your asking how to remove your panels to get at your fuse, let me know and I can explain.

[xxbillay]

ok im heading out to radioshack tomorrow night. soi can just push the wire into the headliner then? i thought i needed to take it down some to push the wires unser it.

[spider_55]

ok im heading out to radioshack tomorrow night. soi can just push the wire into the headliner then? i thought i needed to take it down some to push the wires unser it.

You can push them into the dash, up the pillar, and along the top of the headliner and it will disappear. No trace! Gone! Poof! Hey where did the wires go?

[WRC]

you can always buy the add-a fuse circuit from pep boys if you don't want to cut/splice into any OEM wires

[Bear-Tweezy]

ok im heading out to radioshack tomorrow night. soi can just push the wire into the headliner then? i thought i needed to take it down some to push the wires unser it.

Post some pics when you get done with your install

[xxbillay]

didnt get to radioshack tonight, so hopefully tomorrow.

[Slinky]

Would you be able to get a part # from radio shack/walmart for this?

270-1204 at radio shack?

[xxbillay]

yup, i got it all wired up. its dark out now, but when i get the cahnce ill post pics. it looks really good. i used a visor mount since i dont have a tint strip