I was wanting to ask you guys a quick question
that would really help me out. I plan on rewiring
my detector so It will be easy to switch out my
detector when it comes time to change cars.
The " Add a Circuit " comes with an end piece that you
just crimp so it makes the Wiring permanent unless
you cut the wire. What I was planning on doing is
cutting off the Crimp connector and adding my own
Barrel connectors to the ends of each wire. This will
allow me to disconnect the wires without having to cut them.
My question is, once these Barrel connectors are connected
do they disconnect or are they permanently attached.
Not sure If I should go with these or Spade connectors.
One other thing, I think it's 16 gauge wire, is that correct?