I'm going home tomorrow night and I'll have a few days to get my stealth V1 installed. (Maybe the CB/scanner too).
Anyway. One of the pics above shows the switch and If I just mount it without modification then it'll stick out too far. 2 of the other pics show a flush install which I'm shooting for.
The other pic is the place I'm mounting the switch. My interior is all black so I figure it'll look factory if I can get it flush.
Any advise? I was thinking about cutting the shaft/ modifying the mute ring but I still can't figure out how to hide the nut.
Maybe I'll just fool with it when I get home and have some tools...