Ok, so I just burned up about 2 hours trying to figure this thing out. I read all of the posts on RadioReference, and the online manual. Maybe someone here knows this.
I programmed my local PDs 800mhz talk groups. I am pretty sure the thing is PROGRAMMED correctly, 3 groups under a system. I assigned a quick key to the system.
So, now how to actually SCAN it... I click on function key, then quickly rotate to show the systems, but the one I programmed does not show up. So where is it hiding?
I can go back to program systems, and wah-lah, there it is. There is a LOT of material on how to PROGRAM the thing, but very little on how you then use that programming to SCAN.
If I hit any quick key during scanning, I just get 3 quick beeps, like an error, and it does nothing.