Search:

I bought one from him.It works great.

I just got a f150 with the chrome grille.Would HP or regular heads be fine? Maybe hint where they should goes as well.I don't have a pic of the front end.I do have a quad system I took off my other...

I cut the receiver extension wire.I need to replace the plug end that goes to the interface.Which type? Thanks

Mine does the same thing but it was only when the radar antenna was in the car.No other time has it done it.

The antenna is in the grill with an open view of the road.I have K,KA max and highway mode on.

Been running the Pro 3600 for last month.Get a lot of short range detecton on KA band.Most of the the locals run C/O so its obvious about the range.Also have some K band speed signs the it picks up...

I moved the ground wire and no more problems.The area I was using for ground was part of the dashboard structure.If you hit with your hand it would go off.So I moved to the kick panel area where...

I just installed a Pro 3600 on my car.When I slam the door the unit turns off then back on.Then a "check display power line" fault shows up.I checked the ground and fuse all appear to be good.Also...

Probably been been mentioned before about removal of old Veil coating but here's what worked for me.Saturate a Mr Clean sponge with ammonia and scrub with very little effort.I could not believe how...

Here is Radar Roy's video on how to hardwire your detector.http://www.youtube.com/watch?v=2D4EizMUhsk

I think the controller was $60 from Beltronics.

'Honest Officer its a pharmacy locator,that's why it has the arrows"

When is it going to be available in NA? Other than "soon" is there a date set?

Fuse #37 under the dash.I have a 2010 and 2011 Ford Fusion.I have the add a circuit for my LI and V1 set up.Its a switched 12V circuit that power off when the ignition is killed.

PM sent

I tried some other solvents,but to no avail.

I did try increasing the mixture.I tried straight from the can.Nothing has worked in getting the stain off the paint.I tried some other solvents from work,it helped some but not enough.Luckily...

The mix didn't work.Oh well.

I put the Veil on my chrome grill and headlights.I used painter's tape to mask off the area.The problem is it leeched under the tape.Now its stained on the silver paint.I tried alcohol and acetone...

http://i287.photobucket.com/albums/ll160/tritonfod/DSC00878.jpg?t=1287946805
http://i287.photobucket.com/albums/ll160/tritonfod/th_DSC00880.jpg?t=1287946952...

Thanks to Cliff for anwering my silly questions.It was fairly simple to install.I put the wiring in the plastic conduit for a cleaner install under the hood.Now I just have to get my setup tested.

I was going to use an add a circuit to the fuse box to power the LI.Since it doesn't have a fuse is it still OK to use the add a circuit? And if yes which fuse to fill the add a circuit? Thanks.

I had the radarbusters link on my favorites.Its the same one from the banner but I didn't click on the banner before I ordered.

No, I bought it through the Hayneedle site.

After 6 months of delays I bought an LI Dual from Radarbusters today.Most of the delay was due to my car being in and out of the service department.Ford stepped up and bought back my car.

I...