rookie here, finally i took some pic with my setup , is an audi a6 , i install zr3 . the one in the front was a pain , because i end up made extra brackets , the hood is in angle.. the heads are facing front perpendicular but not so parallel with the street, i hope is not affect the performance. i add pic with front of where are located ,and overall how visible they are. if i use flash on camera u see them better. the rear is mounted better, facing front and parallel. any feedback would be great , let me know what you think. also i couldn`t install in lower grills. the supply is electric mirror , i solder the wire on the fuse blade, because is on ignition.
i am not sure if this is the place where i should post this tread.