Acura TL LI Quad HP/STI-R/Valentine One Install

[Woodscolby]

I got my LI and my Laser Atlanta Speedlaser-R yesterday in the mail so this morning I went ahead and installed the LI. My dad and I tested both of us shooting 3 passes for each side on normal mode and stealth mode without a reading past 60ft on the rear doing 25MPH. Neither of us got a reading on the front shooting for plate or headlights. The two blinders on front were on when tested and did not hurt the power of the LIs when the LA was used. I will just use them to tell me which side of the car I am being shot from with them. I need to go wash my car now, the front is covered with electrical tape slime from pulling the top two blinders out. Special thanks to Cliff for the discount on the LIs.















This last one is an older picture but it is still the same placement.




Stalker LZ1(Version 2): JTG, JFG
LTI Ultralyte 100pps: JTG, JFG
LTI Ultralyte LR-B: JTG, JFG
LTI Truspeed: JTG, JFG
Laser Atlanta: JTG, JFG
Kustom PL3: JTG, JFG
Kustom Pro-Lite: JTG, JFG

[blackgto06]

smurf yeah little doggy!!!! Very nice man!

[AcuraTL]

Nice. How are your heads mounted? can you get a closeup of the install?

[category4]

Gotta love those HP's, I think they could protect a tank!!!

[CJR238]

The TL's are stealthy to begin with, now that's what i call good overkill! Nice install too.

Where is your STi-R antenna installed? And do you use band seg & RDR?

[radarrob]

nice install

[Woodscolby]

The TL's are stealthy to begin with, now that's what i call good overkill! Nice install too.

Where is your STi-R antenna installed? And do you use band seg & RDR?

The antenna has been behind my bottom right grill for the past 6 months. I have noticed no difference in sensitivity from my last install which it had a clear view of the road. I have Ka segmenting 2,5,8 on, Pop off, RDR off, and Laser off.

[mahjong007]

wow, pretty good installed. looks like your LI will protect you no doubt.

[Woodscolby]

Nice. How are your heads mounted? can you get a closeup of the install?

For the front heads I used the license plate brackets for the LI which I then attached to the 2 plastic covers in front of the engine in the car. Then I just attached the LI's which stick out from the front of the car by about a centimeter. To place the rear heads where I did, the only option I had was to use 3M molding tape because the recessed license plate lights leave nowhere to use the mounts that come with the LI. The trim that I attached the rear heads to is level with the road so all I had to do is make sure that they were mounted straight when I attached the heads.

[jmccam]

Very nice! Just got back from Sherman this evening after buying a home.

TX DPS is nasty with the I/O....let the games begin!