I got my lifespeed remote today, looks great thanks again lifespeed! I wired it up as soon as I got it. Last in anticipation I re-wired the setup again fuse tap into the external fuse in the back of my deck and spliced the ground into the ground of the radio, so I was messing around with it and testing the display with my Comcast remote (no need for bashing on Comcast we went through that already) and everything looked fine. I turned my radio on and nothing happened still responded to the remote control. I turned my sub up all the way, nothing happened. with my door open I turned the lights on and the V1 went nuts, trying to reboot constantly with a very dim display on the actual unit and the remote display just light up all the led's so I immediately turned the unit off, shut the lights off and turned the radio off, then turned the V1 back on and it booted up normal and displayed the remote display showed the a so I closed my door and turned the lights on and nothing happened, I opened my door and nothing happened I closed the door and turned the music on, at a low volume and nothing happened then I turned my radio up to my listening level when I am driving with my sub on and the V1 did the same thing crazy booting and all. I'm pretty sure itís the wiring, and not the unit from V1 or lifespeed. It does it whether or not the remote display is attached, it just started happening and I really hope I didnít f-up my V1. Has anyone had this problem, and if so what can I do to fix it.