-
Newcomer
New V1 displays P on startup
Is it normal for a straight out of the box V1 to display P when starting ?
-
02-15-2007 01:48 PM
# ADS
Circuit advertisement
-
Good Citizen
Mine displays p-o-p when the "pop" feature is activated. A single "p" means that the program is changed from the default settings. You may want to check your programming. http://www.valentine1.com/lab/MikesLabRpt3.asp I don't know why your would have the programming changed from the factory, maybe yours was selected for spot quality checking.
2 V1s 3.826 & 3.864 Bel 895
-
Newcomer
I'm fairly certain it is the single "p" and not "p o p". Is there a way to reset to factory defaults?
-
Old Timer
having
Having pop turned on will show p,o,p during start up. Make sure unit is off, then as you are turning it on make sure you push the knob in and that will allow you to set your V1 the way you want it to be set.
1. Escort Redline 2. Bel STi 3. V1 3.872 4. X50 5.Whistler Pro78SE 6. Escort 9500i 7.Escort 8500 8.Bel 980
11 Cheetah C50, Tom Tom 130, Garmin 265WT/Traffic
12-18 Scanners Pro 43,57,94,96 & Regency (relic scanner)
Uniden BCT8, Uniden 996T
19. Car/President AX144 1981 CB, Wilson 1000 magnet mount
20. Truck/Cobra 18 WXST II CB, 2 Francis Fiberglass whips
21-23 Spectre II RDD, 2 VG-2 Interceptor RDDs
24-25 RS HTX-242 Ham radio, Maxon MURS radios
26. Zaon PCAS MRX collision avoidance system
-
Newcomer
I know what the letters stand for, and how to program it. Is there a way to reset to defaults without going to each setting individually?
-
Good Citizen
Originally Posted by
chase123
I know what the letters stand for, and how to program it. Is there a way to reset to defaults without going to each setting individually?
Not that I know of. To restore defaults just program all arrows up on each step of the programming process, should take less than a minute.
2 V1s 3.826 & 3.864 Bel 895
-
Radar Fanatic
The 1.8's AFAIK will not show a p if it has been changed from its original programming. The LED"s will lightup or not light up on the strength meter based on what selections are on or off.
The 1.8 will on default display p-o-p following the startup sequence to show that POP is enabled. Might want to check again. I'm sure it is just pop on.
For the next question - no way to factory reset - other than all arrows to the up position as stated earlier.
Valentine 1 3.863
Bearcat BC248CLT Scanner
Midland 4001 CB, Wilson 1000 SL
Need Something Shipped Internationally? PM or IM me.
-
Newcomer
Thanks. It is probably the "p o p" message that I am seeing then.
-
Newcomer
Why don't you go turn it off and back on and see if it says p o p when powering up
-
Good Citizen
Originally Posted by
bauzer71487
The 1.8's AFAIK will not show a p if it has been changed from its original programming.
My 3.826 is custom programmed with the pop off, it displays a single p on start up.
2 V1s 3.826 & 3.864 Bel 895
Posting Permissions
Bookmarks