I am normally very good at following directions.
I have followed the directions exactly
for options B-g on my 3.861 but it still doesn't auto mute. I realize this only works in L and l modes and that A mode is like it was never programmed.
I was at a supermarket today so it was a great place to try out the programming. I was going right off of mikes programming guide from valentine1.com. I had it in my hand as I was programming. I also read the threat in the V1 forum to make sure I wasn't misunderstanding something.
I was still getting audible alerts at even 1 or 2 bars when it was set to automute for 15 seconds and not unmute until 4 bars. I had the same results in both Big l and little l mode. However, i did notice it seemed to take a little bit longer to recognize the alert (like it was suppressed somewhat).
Here are my exact settings:
7: Down (enabling the b-g settings)
D: Up (This combo should give me 15 seconds of muting time for versions higher than 3.821 and i have 3.861)
E: Up (But it never can unmute because it never muted to begin with)
Any ideas?? Hopeuflly I am missing something and don't need to send the V1 in.