I have a Valentine V1 ver. 1.7 I believe. I must say it works pretty well, but the arrows have never worked right. I was headed home last night doing the psl. The V1 lit up with the REAR arrow and the strength gradually made it to full. About 1/2 mile after the first beep, there was an officer parked on the opposite side of the highway facing the opposite direction I was headed. I'm assuming he was pointing the radar gun at the traffic on his side of the highway out the read of his car. (I've included a picture so I hope that helps.) Once I pass him (now in the line of radar) the V1 stays at full strength with a rear arrow for a few miles until it gradually fades. The number was fluctuating from 1-3 during this period. Heres the problem: I've never seen anything but a rear arrow on the V1. It is always the rear arrow and or the sideways ones. Never ever the front arrow. Even when I'm headed directly toward an officer, I get a rear arrow. It does this in other vehicles so I know it's not the position of the V1. What could be the problem? Is there a way to hard reset the V1 or something?
Here is the situation: