Rear Mounting Location on Porsche 997?

Quote:

---

Originally Posted by yellowcab

To save money you could go with a LI dual up front and a LI HP dual in the rear.

---

x2 probably the best route you dont really need HP up front and you'll know if u get hit in the front or rear

Quote:

---

Originally Posted by Car-Nar

OK. OK. You make a good point and I've further researched the 9500ci and I'm not liking what I'm reading. So back to the LI's... two LI's will not fit above the rear license plate without covering the license tag lights. One will fit fine (in between the two lights). Should I just get one high power LI and put it there?

FWIW... I'm going with the STI-R Plus RD.

---

Lol. Both will fit fine. What you can not see in the picture above is the complexity of bracket that holds the LI sensors. It is mounted using existing holes, it levels and aligns both heads, and it incorporates new LED lighting which is wired into the factory license plate lamps which are partially covered. And it does all of this with an unobtrusive footprint. The lighting on that plate is much more vivid than it was before. Did I also mention how well the setup performed in my post above?

Quote:

---

Originally Posted by PMoth

...it incorporates new LED lighting which is wired into the factory license plate lamps which are partially covered.

---

So this bracket has its own lights?

Quote:

---

Originally Posted by Car-Nar

Quote:

---

Originally Posted by PMoth

...it incorporates new LED lighting which is wired into the factory license plate lamps which are partially covered.

---

So this bracket has its own lights?

---

Yes sir it does.

I have my LI's in hand now and there is no lighting on the brackets.
:confused:

In this picture would green work?
Yellow would be my second best (looking) location but Cliff says not to do that.
Red is fine.
Purple aint gonna happen.

Green is very low and I suspect the heat will cause damage to your system. Yellow is not advised. LOL about the purple. You sound just like the owner of the C4s picture I posted above. Red is your only option. You must have misunderstood what I said in post #12. The bracket used was created for that particular application. It was not provided by Laser Interceptor. It was a 911 specific piece created for that owner. It mounted to existing screw holes behind the plate and also to the screw holes for the license lights. And because it partially blocked those lights, it has LED lighting incorporated into it.

I thought red would be the only feasible location.
Do you have any other pictures of the custom mounting plate on the 997?

Quote:

---

Originally Posted by Car-Nar

I thought red would be the only feasible location.
Do you have any other pictures of the custom mounting plate on the 997?

---

Unfortunately, no. It was a one-off piece created for that application.