self calibrated my rx65 with a miniature screw-driver and yields better sensitivity and performance. bought from radar roy, owned for almost 3 yrs service require displayed once. so far so good just love it.
regards
derence
SINGAPORE
Printable View
self calibrated my rx65 with a miniature screw-driver and yields better sensitivity and performance. bought from radar roy, owned for almost 3 yrs service require displayed once. so far so good just love it.
regards
derence
SINGAPORE
please explain
is there adjustable screws inside
how did you do it
I wouldn't recommend it dude. Unless you know what you are doing - tighten too hard and you could make it an expensive paperweight or windshield ornament.Quote:
Originally Posted by philnz
Sounds like trouble to me...
how do u do something like that? in detail explain how u did it.. also, why dont the companies just increase sensitivity right off the back? or will it false more?
Remove the back cover of the horn antennae and there is a potentionmeter - (not sure the correct name) and with a miniatureQuote:
Originally Posted by alias3r
flathead screw driver to turn anti or clockwise but patience is very much
needed to tried out at several point of locations.
Interesting if you control frequency sensitivity. It was never clearly explained if I enable POP band will sensitity be increased against the 33.8Ka band range and reduce others.
without the proper equipment, lots of trial & error inorder to determine the best sensitivity. My only advice is be very careful whilst turning the miniature screw - do not force the screwdriver on it and turn it slowly and carefully. Honestly, I've done it successfully and I post it on this forum to help those who encounter such problem likes service required.Quote:
Originally Posted by Toronto-radar-chopper