I just ordered a Beltronics STI Professional Radar Detector and it comes with a direct power cord. The instructions for this are as follows....
First off theres only 1 crimp but theres a speaker and a exterior switch that both need a crimp... did they jip me or is it only supposed to have 1?Quote:
Direct-Wire
Power Cord
The Direct-Wire Power Cord comes with connectors to allow easy hook-up to your car's electrical system.
The black ground wire is fitted with a lug to allow it to be installed under any grounded screw under your vehicles's dashboard.
The red striped wire for +12 volts is fitted with an insulated 1/4" male spade lug. We also have supplied a special 3M connetor that allows you to tap into an existing wire in your vehicle. This connector can be used only with wire guages 14 through 18.
To install the connector, position in around the wire you wish to tap into, and squeeze it with pliers. The Direct-Wire can then be plugged into this connector. Make sure the clear insulator sleeve on the Direct-Wire completely covers the connection.
Basically I am trying to figure out what wire is best for this crimp and how best to get at it. I drive a 2005 mustang GT, and have lots of wires under my dash by the pedals but dont know if they are best. Also how do you thread the wire through a dash? Thanks a mil for the help!
-James
