I've just installed my new m-20 and everytime I start it it resets after 30 seconds then its fine. Anyone heard of this? It is installed correctly with all the proper conections and sensors are level. thanks
Sean
Printable View
I've just installed my new m-20 and everytime I start it it resets after 30 seconds then its fine. Anyone heard of this? It is installed correctly with all the proper conections and sensors are level. thanks
Sean
I've just tested my v1 and blinder with my sony tv remote and it sets them both off. The blinder will only go off a couple times before its logic kicks in I guess. So I know the blinder is working it just resets after 30 seconds.
Has to be a short somewhere or could just be glitch. hope it doesn't turn out to be a lemon. One question i have is what is the temperature there? not that it should effect it much but if it's pretty cold it could.
its about 75 degrees here in orlando, i'll call blinder tommorrow and see if Leon knows what it means
I just got off the phone with Leon from blinder and he said that someone was supposed to put another manual in the box explaining the new test mode. Since people complained about not knowing if their units were working and so you don't have to buy a tester, for the first 30 seconds its in a test mode. For those 30 seconds you can aim a tv remote at them and it will set the alarm off, I tried this it works. Then after 30 seconds you will hear 2 beeps and the light will turn red, then back to green, like it reset itself, after this initial test mode everything is ready to go! thanks Leon
Sean
whoa!! that is a sweet idea - props Leon and the team :)
Just found this out myself, sweet!!Quote:
I just got off the phone with Leon from blinder and he said that someone was supposed to put another manual in the box explaining the new test mode.
Smart idea Leon!
I agree that is a real good idea, whoever thought that up.Quote:
Originally Posted by thestaton