Re: Redline problem again
Re: Redline problem again
How does the unit work on other known sources?
Re: Redline problem again
Re: Redline problem again
Re: Redline problem again
Quote:
Originally Posted by
CJR238
What frequency?
24.056
Re: Redline problem again
Quote:
Originally Posted by
OpenRoad
Quote:
Originally Posted by
CJR238
What frequency?
24.056
Exellent question CJ!
And whoa........just 6MHZ inside the normal K Bandwidth (24.050 - 24.250).
I believe that's why your RedLine is cutting in and out on you OpenRoad......the frequency of that speed sign is hovering right on the fringe. The M3's frequency readout is fairly accurate but not absolute, so the gun itself could be entirely out of spec. The radars in those signs are usually old beaten up units to begin with, then they finish life doing 24 x 7 shifts in a trailer! The RedLine itself might be running a little tight on the low end but I'd give the bulk of the blame to that radar unit. After many many hours of continuous operation the gunn diodes wear out and drift way off center.
Re: Redline problem again
Quote:
Originally Posted by
nine_c1
Quote:
Originally Posted by
OpenRoad
Quote:
Originally Posted by
CJR238
What frequency?
24.056
Exellent question CJ!
And whoa........just 6MHZ inside the normal K Bandwidth (24.050 - 24.250).
I believe that's why your RedLine is cutting in and out on you OpenRoad......the frequency of that speed sign is hovering right on the fringe. The M3's frequency readout is fairly accurate but not absolute, so the gun itself could be entirely out of spec. The radars in those signs are usually old beaten up units to begin with, then they finish life doing 24 x 7 shifts in a trailer! The RedLine itself might be running a little tight on the low end but I'd give the bulk of the blame to that radar unit. After many many hours of continuous operation the gunn diodes wear out and drift way off center.
Exactly why i asked. Thank you. :cool:
Re: Redline problem again
I think this is an antenna issue with loose internal connection. Note when I'm stopped dead in front of the sign, as soon as I start to pull away it alerts - likely from the bumpy road causing it to make contact again.
Unfortunately the video scan rate makes the speed sign unreadable, but you can see it shows speed when cars go by. The video is a little long, as I spent all of 3 minutes editing it....
http://www.youtube.com/watch?v=0Ks_kvkVw6Q
Re: Redline problem again
Quote:
Originally Posted by
CJR238
Quote:
Originally Posted by
nine_c1
Quote:
Originally Posted by
OpenRoad
Quote:
Originally Posted by
CJR238
What frequency?
24.056
Exellent question CJ!
And whoa........just 6MHZ inside the normal K Bandwidth (24.050 - 24.250).
I believe that's why your RedLine is cutting in and out on you OpenRoad......the frequency of that speed sign is hovering right on the fringe. The M3's frequency readout is fairly accurate but not absolute, so the gun itself could be entirely out of spec. The radars in those signs are usually old beaten up units to begin with, then they finish life doing 24 x 7 shifts in a trailer! The RedLine itself might be running a little tight on the low end but I'd give the bulk of the blame to that radar unit. After many many hours of continuous operation the gunn diodes wear out and drift way off center.
Exactly why i asked. Thank you. :cool:
I'll go with that for now, and do a bit more checks. Kinda scary to see a sign reading speed on cars with no alert, or a scattered one.