LI install Dodge SRT

http://www.delonixradar.com.au/laser...s/DSC00708.JPG

http://www.delonixradar.com.au/laser...s/DSC00709.JPG

http://www.delonixradar.com.au/laser...s/DSC00710.JPG[/img]

Thank you both

That help out a lot

:) now i can put them back on

Ok, i need help. Im gonna go crazy.

I though there was a lip under the car that would allow me to put the heads in about half inch under the bumper. Well there isnt. there is no room under, and almost NO lip for me to screw the brackets on. When i do just screw them on they are very off set, they will either face to the left or to the right not center. That is where i run into a problem. I try to move it more to the left myself to make it center but then i wont be able to screw the other side of the head onto something to make it secure.

What the hell. Who else has an neon srt4 and where did u put your heads in front and how??

noTe has an SRT-4.

Also, remember that 3M Double sided tape is your friend :)

Quote:

---

Originally Posted by ELVATO

noTe has an SRT-4.

Also, remember that 3M Double sided tape is your friend :)

---

Thanks i already asking him. Gave me a good tip.

3m dst huh, dont you think the heads are a little heavy for the tape and might fall off

Quote:

---

Originally Posted by muledoe1

Quote:

---

Originally Posted by ELVATO

noTe has an SRT-4.

Also, remember that 3M Double sided tape is your friend :)

---

Thanks i already asking him. Gave me a good tip.

3m dst huh, dont you think the heads are a little heavy for the tape and might fall off

---

I don't know how heavy that LI head is, but my LPP head is only secured with 3M tape. Just make sure your clean the area well with alcohol, and everything should work just fine.

Im just going to remove the bumper and it will make it much easier on making sure they are center as possible too. Not enough room for the tape, its a very very small lip. Sucks.

No offense but I would never put 3M tape for the LI sensors. Especially on a car that can easily go 100 MPH quickly, and the risk of some jerkoff trying to steal LI sensors. Also, they would be screwed into the bumper and be hard to remove and that was my #1 reason for doing it to my bumper.

Quote:

---

Originally Posted by noTe

No offense but I would never put 3M tape for the LI sensors. Especially on a car that can easily go 100 MPH quickly, and the risk of some jerkoff trying to steal LI sensors. Also, they would be screwed into the bumper and be hard to remove and that was my #1 reason for doing it to my bumper.

---

agreed. Well ill post some picture of the set up after i get the bumper off and find some places to place em

Is bumper removal, really necessary? They should be level. You really should make sure they are level once they are on the car.