have just got v1 second hand
is running A
how do you change between a,L,l
it says nothing in the reprograming of v1
cheers
have just got v1 second hand
is running A
how do you change between a,L,l
it says nothing in the reprograming of v1
cheers
Just press the volume knob as if you are muting it but hold it for a few seconds and it will change to small "L". Do the same thing to change it to big "L" and "A".
When V1 is powered and turned on, press the knob for couple of seconds.Originally Posted by philnz
cheers guys
we only have ka and laser here
does the L ,a l settings affect/block out on this band or are these settings for k and x only
X Only according to VR, unless you reprogram it
In the All-Bogeys® ( ) mode, all bogeys will be reported
as soon as they are detected. Use your judgment to decide
whether or not they are threats.
In the Logic® ( ) and Advanced-Logic® ( ) modes, you are
deferring to the internal computer which will use its own
logic to screen bogeys before reporting them to you.
In Logic, X-band bogeys the computer judges to be
non-threatening will be reported at the “muted” volume. If
they become threatening, the audio warning will upgrade
to the “initial” volume before you are within radar range.
In Advanced-Logic, X-band bogeys that the computer has
reason to believe aren’t radar will not be reported at all.
One exception: To be failsafe, the computer will always
pass extremely strong signals along for your judgment.
This mode is particularly useful in metro areas.
The computer is smart: It never operates the receiving
circuits at less than maximum sensitivity and it knows that
Instant-on is a greater threat than ordinary radar. So it will
always warn you immediately at the “initial” volume when
those radars are detected, no matter what mode you’ve
selected.
To change modes, press and hold the Control Knob for
one second.
you can also reprogram the v1 so that it just alerts you to laser and ka band!
see mikes how to on his site
http://www.valentine1.com/lab/MikesLabRpt3.asp
make sure that the police dont use the bands before you turn them off!
(I) & (L) mode is for X band only unless reprograming K band automuting but 3.824 has the software flaw that will never allow you to use this function.
Sounds like you did not get a manuel, time to read up.
http://valentine1.com/Moreinfo/pdf/V...al_2005-i4.pdf
Perhaps the FCC should tighten the requirements of detectors that leak. After all it is unwanted and unintentional (not deliberate) transmission imo.
Unidens and Whistlers are worthless imo anyway.
Bookmarks