Leveling the 9500ci Shifters

**geekmedic** · 07-06-2009, 05:38 PM

What's the best way to do this? I'm assuming both the top and bottom block areas are where to measure it being level (although I think I remember reading that only the top was level on the 9500ci's shifters??).

I tried doing it with a digital level after resetting it (calibrating it) for the garage being off-level (figured the car was off-level sitting in the garage). Got it to 0.5 degrees off. However, I'm wondering if I did it correctly since it's so hard to get a metal ruler to sit in the little square block in order to calibrate things.

Any tips?

**mrcllusb** · 07-06-2009, 05:41 PM

When i did mine originally,i used just a plain mini bubble level.Didn't one come with your kit?

**geekmedic** · 07-06-2009, 05:46 PM

Originally Posted by mrcllusb

When i did mine originally,i used just a plain mini bubble level.Didn't one come with your kit?

No, unless the installer took it with him.

**category4** · 07-06-2009, 06:02 PM

I use a little bubble level that came with my LI's.

If you got it within a 1/2 degree you are probably pretty good.

PM me if you want to test them out. I live NE of Atlanta near the Mall of GA.

**mrcllusb** · 07-06-2009, 06:18 PM

He just might of.I remember a level coming with my gear when i ordered my LP905.

**geekmedic** · 07-06-2009, 06:42 PM

These are ZR4's with a 9500ci package. Not sure Escort puts a level in the kit. I know LI and LP's come with them (from what I've read on here).

I'm hoping I can talk MEM-TEK into modifying them.

**languy99** · 07-06-2009, 07:15 PM

blinders also come with a level and I think even laser mask does. How cheap is that of belscort, a $1600 system and they will not throw in a 16 cent level from china.