Hi all,
Looking for a little assistance or recommendations on installation for a BMW K1300S motorcycle for best results and a clean look. Any help would be much appreciated!!!
Hi all,
Looking for a little assistance or recommendations on installation for a BMW K1300S motorcycle for best results and a clean look. Any help would be much appreciated!!!
These folks bent over backwards to help me with a V1 install on my BMW F800 ST. But this really slick mount is only for the 1200 and 1300:
Pirates' Lair Stealth Radar Detector Mount from Pirates' Lair at 828.628.7093 EST
-dan
Thanks Dan,
Mount was ordered but wiring is more the question (sorry I was not more specific) I also have a M27 Blinder ordered as well (local law enforcement has tripled in the last 6 months looking for more revenue at any cost)
It's easiest to avoid CANbus issues by wiring direct to the battery, using the V1's hardwire adapter and fuse.
If you really have to have it controlled by the key for some reason, I'd recommend this fuse block and relay setup, which can use either the parking light or OEM GPS circuit to trigger the relay without getting the CANbus all bent out of shape:
FUZEBLOCKS.COM
-dan
Thanks Dan,
That is good advice about the CANbus system and hard wiring looks light the route to go. I will disconnect the V1 and put it in the car when my weekend rides are done
Last edited by soundpros; 11-03-2009 at 10:06 PM.
Bookmarks