View Full Version : bel rx-65 alot of problems
busa1018
05-30-2006, 09:23 PM
having a bit of trouble with my second rx 65. got it hardwired to my 2002 hayabusa and every now and then i get a low voltage message then it shuts off and restarts. then it starts to go crazy at times and even shuts off and i have to unplug it and then replug it to turn it on. the wires are now striaght to battery so it is not the wiring. i used two different hardwires and two rx65 radars and still the same. can it be getting to much jucie or what. please help me out
crazyVOLVOrob
05-30-2006, 10:37 PM
The BEL have been know to have problems when there is a power surge at start up
busa1018
05-31-2006, 06:26 AM
so what do i have to do
AirMoore
05-31-2006, 09:00 AM
so what do i have to do
Now I assume (from what you have said) you have the Bel or V1 hardwiring kit in use on your Busa? If not you should use the Belscort, or V1 hardwiring kits, all of which can be bought seperatly from the unit(s).
Doesnt your Busa have ACC outlets... which remain perminantly on, I would also use those rather then the battery itself.
Have you used a voltmeter (multi-meter) to check the voltage levels?
Any Self-Cal/Service Req messages?
As for what to do to protect the RX-65 from powersurges on start-up, make sure the bike is on and running at idle before putting the RX-65 to use.
busa1018
05-31-2006, 07:52 PM
voltmeter checked out ok. between 12 - 14 volts 14 at high idle. yes i have the bel hardwire kit. no check messages anywhere and never happened. what next. i need help before buying new val 1
crazyVOLVOrob
05-31-2006, 09:18 PM
voltmeter checked out ok. between 12 - 14 volts 14 at high idle. yes i have the bel hardwire kit. no check messages anywhere and never happened. what next. i need help before buying new val 1my guess is it's thw wiring thats at fault not the detector
busa1018
05-31-2006, 09:32 PM
tried two sets of wiring
radardude
06-09-2006, 01:03 PM
Try leaving a volt meter attached and the next time it happens check to see how low the voltage dropped. If it drops below 12 the problem is probably not the detector nor the cables.
dcbikerrick
06-12-2006, 11:09 PM
You won't see this without an oscilloscope (it happens too quickly to see on a meter) - the voltage can drop below 12V when the motor starts, and shoot up a bit before the regulators catch it.
If you're getting the voltage from the bike's 12V harness, you can try wiring it directly to the battery - the surge should be less here.
If you're already getting it from the battery, see this URL:
http://www.allbusiness.com/periodicals/article/877307-1.html
This guy rebuilds the stators on Hyabusa's, and I he knows 10x more than anyone you could talk to. His contact info is on the web link - I'd call, vs. sending an e-mail.
Good luck with your Rocket!
Rick