View Full Version : Veil on Laser Shield
EastGermanOlympicJudge
06-02-2005, 04:34 PM
Hi all. Not really sure where this thread belongs, so I'll put it here. Please move me if it's appropriate to go somewhere else.
Anyway, I just got my Laser Shield (thanks Roy!) today, and wanted to Veil the little sucker. I know I'm supposed to Veil the "inner" side of the Shield. But the instructions say that the rough or "textured" side should be facing inwards, towards the plate, not away from it. I was certain I had read somewhere here that the rough surface should be facing outwards, not inwards.
Anyway, would someone please confirm for me which way it goes? Thanks!
Radar Roy
06-02-2005, 04:46 PM
The instructions on the raised side are for the other covers, not the shield
crazyVOLVOrob
06-02-2005, 04:56 PM
I could of sworn the directions i read say the rough side goes out...which makes the most sense
EastGermanOlympicJudge
06-02-2005, 05:04 PM
I'm so confused. :(
http://www.availabledark.com/~colin/images/shield01.jpg
crazyVOLVOrob
06-02-2005, 05:17 PM
my instructs didn't look like that and I still got it from roy?????
happya$$
06-02-2005, 05:25 PM
Mine said rough side outwards away from the plate and towards the source
kai445
06-02-2005, 07:38 PM
Crap... I got mine from roy and just sorta assumed the rough side faced out...
roy, care to clarify?
(Laser Sheild)
happya$$
06-02-2005, 07:41 PM
Roy will tell you the same thing that I just did which is rough side facing the laser source NOT the plate
brick
06-02-2005, 08:01 PM
I say test it out with a laser pointer or something and see what diffuses the light better.
happya$$
06-02-2005, 08:03 PM
Who is the manufacturer of the Laser Shield?
robert
06-02-2005, 08:23 PM
now everybody has to re-do all their videos. :lol:
jbird
06-02-2005, 08:27 PM
I truly doubt that it matters much. The bottom line is that the lidar beam has to pass through both sides to get to the plate then back out both sides. Maybe if the smooth side somehow reflected the lidar beam back to the gun before it has been difused then it would be better to mount the rough side facing out like I did.
The truth is the product looks like someone has taken sandpaper to clear thin piece of clear plastic and made one side pretty rough yet remain mostly translucent in appearance. The rough surface just scatters the lidar beam as it comes in and also scatters the reflection off the license plate. This helps defeat the ultra-reflective coating on the license plate and reduce the plate as a factor. My guess is that you could sand down clear plastic headlight covers to get the same effect and just remove them at night. This would assist and protect Veil on the headlights too.
crazyVOLVOrob
06-02-2005, 09:55 PM
Mine said rough side outwards away from the plate and towards the sourcethats what i thought it makes more sense