PDA

View Full Version : Something in my car setting off LASER??



NYDesi80
07-20-2005, 10:41 PM
Hi guys, my firts post but long time lurker and viewer. I finally just purchased a V1 unit and am so excited and just today finished harwiring the unit into my car.

Now here's the issue... something in my car is setting off the Laser alert and dont know what it could be. I have an 2003 Acura TL TYPE S. How I know its in the car is because when I point the radar detector towards my radio the Laser alert goes off. I ruled that it isn't my radio as I shut if off nor my navigation as I turned that unit off too but the Laser goes off still. When I have it mounted on the windshield its' fine, but I did notice that the range on the unit isn't as great as the x50 that I had for short while.

I have my windshield tinted with Llumar tint. Both radar detectors were compared detecting through the tint. Any ideas if my unit might be defectve?

sethy
07-20-2005, 10:42 PM
V1 is an excellent unit. Is the laser going off when you set the cruise cotnrol?

NYDesi80
07-20-2005, 11:30 PM
I dont have laser guided cruise control in my vehicle. And also the alerts were going off when the car was parked.

Someone just mentioned to me that the Laser alerts go off by LED's or even cars that have LED brake lights even?? My radio does have a small LED. You think this can be the culprit?

BlindWildWind
07-21-2005, 01:57 AM
As far as LEDs go their is no way an LED could cause a LASER warning, it would have to be something that emits a signal LED's do not. But weird things cause LASER alerts on my rx65, like car horns, or my old 88 truck door opening.

nomotickets
07-21-2005, 06:06 AM
Just last night I passed two police cruisers who had their blue & reds going (they were directing traffic). Within 50 yards my Laser warning went nuts, then stopped, then went nuts again. This happened 3X in a row. No one was in the cruisers - both cops were out in the traffic. I figured it might have had something to do with the blue and red strobes.

Also, I read that it is neon that can set off the Laser warning, not LEDs.

kpatz
07-21-2005, 07:03 AM
The laser sensor responds to pulsed infrared signals. So if it falses, it's picking up pulsed infrared from something. Strobes on emergency vehicles are a common culprit. So are neon signs or neon brakelights. Some TV remotes can trigger the laser alert, if you point it at the detector. LEDs shouldn't set it off, unless they're pulsed and emitting in the infrared range.

Does your car have any kind of onboard computer with an infrared link, say to sync to a PDA (not Bluetooth, that's RF based)? That could be it. Get or borrow a digital camera or camcorder with a Nightshot (night vision) mode and aim it at the radio and see if it picks up any IR emissions.

Oh yeah, in BlindWildWind's case, electrical noise can sometimes trigger the laser alert as well. I don't think that's the case here though, since it only goes off if the V1 is pointed at the radio.

brick
07-21-2005, 07:41 AM
Someone posted a while back about the LCD display in his Prius setting off the V1 laser alert. I think he had to build a little shield on the V1 so that it couldn't see the monitor. I know you say you turned off the navigation, but is the display itself turned off completely? Perhaps you could cover it with a piece of carboard or a towel just for testing?

jsirovic
07-22-2005, 03:38 AM
Just turn off laser on the V1 and get a Blinder. The Blinder doesn't false -- or dismiss laser that the blinder doens't pick up.

The processing in the Blinder filters very well. When I see my V1 go off and the blinder doesn't, I know it's a false.

LAFENGAS
07-22-2005, 10:34 PM
GMC Envoy brake lights DO set off the laser. Fact.

midd
07-23-2005, 07:46 AM
LAFENGAS is correct. Mainly the newer GM and GMC SUV's use a newer kind of brake light that when the brake pedal is depressed, your V! will scream Laser like a wild banshee.

quandary
07-23-2005, 08:46 AM
I also had a similar problem and it was a fault in the unit. I was getting laser intermittently. You might want to have it checked out too.

subaru4wd
07-27-2005, 02:33 PM
Voltage drops can cause laser flase alarms.
I once connected my V1 in parallel to the horn and when I used it it went wilde.

nomotickets
07-27-2005, 02:37 PM
Voltage drops can cause laser flase alarms.
I once connected my V1 in parallel to the horn and when I used it it went wilde.

:lol: That's pretty cool! I'm going to have to try it!! :lol:

subaru4wd
07-27-2005, 02:40 PM
100%,
The good thing about it is that you will think twice before using the horn...

kpatz
07-27-2005, 02:46 PM
Voltage drops can cause laser flase alarms.
I once connected my V1 in parallel to the horn and when I used it it went wilde.That actually makes sense, as the horn generates a lot of electrical interference with a pulse frequency comparable to a laser gun. So naturally it's going to drive a sensitive V1 nuts. :lol:

I once had a Uniden Stalker :roll: that would sound laser alerts under different conditions in different cars I drove. In a '87 Toyota 4Runner, it sounded laser when I ran the wipers. In a '94 Ford Taurus, it would go off when the power antenna went up or down. In a rented '97 Buick, it sounded when I moved the shifter in or out of Park.

CorpRaid3r
08-01-2005, 01:11 PM
When I installed my V1 in my dad's 745Li, it would give me a Laser warning if I put it near the on board computer screen...The Envoy's brake lights and other cars brake lights set the laser warning off too.

SpeedFreak
08-01-2005, 01:34 PM
I tried a 05 GMC safari and when i was holding the pedal to half throttle my X50 was going off crazy on laser.I putted it on the dash,windshield and even the seat and there was nothing to do.

subaru4wd
08-02-2005, 03:16 PM
Guy's,
I wrote the reason in the first page.
false laser alerts usualy caused by voltage drop, make sure the V1 is hard wired directly to the fuse box and not in parallel to a horn or other high currecnt consumer.

SpeedFreak
08-02-2005, 05:18 PM
I checked the the voltmeter and it wasnt moving at all. I think its coming from under the hood.

subaru4wd
08-03-2005, 02:39 AM
If the voltage is shorter than that your voltmeter can pick up,
it won't help you.
good luck :shock:

billgerr
08-03-2005, 07:34 AM
Something on I-30 dash sets off V1 laser warning. No other RD tested reponds this way. V1 may have much wider range into red than others.

lordhamster
08-03-2005, 08:07 AM
I tried a 05 GMC safari and when i was holding the pedal to half throttle my X50 was going off crazy on laser.I putted it on the dash,windshield and even the seat and there was nothing to do.

I know this if off topic, but I had the misfortune of driving a GMC safari several years back. OMG it was the biggest piece of CRAP I've ever had the misfortune of driving. I does not surprise me that the electrical system is flaky

SpeedFreak
08-03-2005, 07:04 PM
I know this if off topic, but I had the misfortune of driving a GMC safari several years back. OMG it was the biggest piece of CRAP I've ever had the misfortune of driving. I does not surprise me that the electrical system is flaky
LOL, dont know if you were driving a passenger one or a commercial one but i think it does its job really well. Im not a big fan of this model but i think its good for businesses.

ghz1
08-04-2005, 05:30 AM
My V1 Lazer alert can go off when i point the remote for the DVD at it and press play.you may find your stereos gives off a light beam thats close to the cops 904 nm lazer gun good luck.