View Full Version : V1 on hayabusa
sbfuller2
01-30-2008, 04:29 PM
just thought some of you with bikes would like to see this. i made a small mount out of a small piece of aluminum brace from home depot, and bent that then bolted it to the frame at the back of the speedo... used industial velcro from target, and hard wired the RD in to the system.
http://i275.photobucket.com/albums/jj294/sbfuller/DSC00264.jpg
tnharley
01-30-2008, 05:03 PM
Good job! Do you have some closeups of just the mount? Jerry
sbfuller2
01-31-2008, 08:45 AM
Good job! Do you have some closeups of just the mount? Jerryi can take a few tonight... i'll post tomorrow morning with them
Sweet setup, and sweet bike.
What method did you use for wiring up the power?
Do you use any external devices to the V1 to help alert you while riding?
sbfuller2
02-01-2008, 11:46 AM
Sweet setup, and sweet bike.
What method did you use for wiring up the power?
Do you use any external devices to the V1 to help alert you while riding?i just hard wired it with the kit that came with the V1, and external devices, i have the additional audio box for the V1 that i'm trying to make a screamer out of... i think i just need to get the remote display, and wire the leads to the first little LED for signal strenth to a relay and use that to power the screamer siren. the audio jack doesn't do that so well.
tnharley
02-05-2008, 07:48 PM
Have you had a chance to take some close ups of the mount yet? Jerry
AirMoore
02-07-2008, 07:34 PM
VERY NICE, I'm not a huge fan of the V1 on a bike, but that is a very clean install.
sbfuller2
02-22-2008, 10:40 AM
Have you had a chance to take some close ups of the mount yet? Jerryyes i have...
http://i275.photobucket.com/albums/jj294/sbfuller/radarmount.jpg
it is actually bolted into a hole predrilled into the frame at the back of the speedo cluster. it is level despite how the picture looks.