View Full Version : Blinder Questions
COBEL
02-09-2005, 11:10 AM
What is involved in installing a Blinder M20 and how long does it typically take? How are the sensor wires run to the cab area to the alarm and switch control? Is drilling required to attach the sensors or run the wires?
What is the false alert rate on the Blinder and what types of things cause false alerts?
direct sunlight?
cruise control laser on some cars?
wind shear lasers near airports
middle rear brake light on some cars?
other laser sources?
sethy
02-09-2005, 11:55 AM
I would also like to know if you can turn the blinder off from inside your car
happya$$
02-09-2005, 02:32 PM
Yes you can. I will post pictures of what the darn swich looks like. All it is is a little siwtch with a LED. It stays green when you are not lasered. It turns red when you are lasered and a HIGH pitch sound alerts you. YOu never get falses from the Blinder. When it sounds you are 100% being lasered
COBEL
02-13-2005, 08:22 AM
I found installation manuals for the Blinder M10, M20 and M40 here
http://www.blinder.dk/uk/install.htm
Radar Roy
02-14-2005, 11:44 AM
Sorry that it has taken time to respond, was gone over the weekend
You have two laser jammer heads that go to the front. You would install these between your front plate and the headlamps in the grill of the car or under the bumper.
These get plugged into the controller box.
Leading out of the controller box are three wires: red, black and blue
The red goes to a hot 12 volt source
The black to ground
The blue to your car radio if you have a mute function installed in your radio. If not, just cut the wire
Another cable comes out of the controller box, this has the buzzer, the led light and the power switch connector.
You can tape the buzzer under your dash
The light you can mount in your dash, or have hang out in some visible location. The switch can be dash mounted or taped under the dash
Install time 2 hours
marlinspike
02-14-2005, 11:52 AM
Install time 2 hours
Assuming you don't have a W126 Mercedes where it's a real PITA to get from the engine bay to the interior I presume.
Richard
SmaartAasSaabr
02-14-2005, 03:20 PM
Or an Audi 5000/100 (a la 60 minutes)