Governator
09-09-2008, 08:56 PM
Ok what kind of voodoo must we use to get this stuff to work? The cable I'm using is below:
IOGEAR - GUC232A - USB to Serial/PDA Converter Cable (http://www.iogear.com/product/GUC232A/)
I'm on Vista 64 and the mobo I use has had it's lone on board serial port disabled since day one since I use no serial devices. I installed the drivers from IOGEAR's site for 64-bit Vista dated Aug '07, it installed itself to COM4 port then started the LI settings app and no joy, tried all ports actually...nothing with the error below:
sEvent function called.
1 port not opened.
Technical Information
Project : jammer
Dump error of module <WD110COM.DLL> <11.00Ef>.
- WL Call:
Processing <frmmain.btnConnect>, line <24>, thread <0>
Function <sEvent>, syntax # <0>
- Level: fatal error (EL_FATAL)
- Error Code: 100161
- WD55 Error Code: 0
- No system error code
- No system error message
- What happened?
1 port not opened.
- Debug Information:
Fonction (10,148)
- Attached Information:
EIT_DATEHEURE : 09/09/2008 19:53:11
EIT_PILEWL :
Click btnConnect (frmmain.btnConnect), ligne 24
- No identifier in .err
Help
Is the CPU designed to work right out of the box or do we need to set it up first?
Update: Got it fixed, had to reassign a few ports but now reads as below:
ATEN USB to Serial Bridge (COM1)
:beer:
IOGEAR - GUC232A - USB to Serial/PDA Converter Cable (http://www.iogear.com/product/GUC232A/)
I'm on Vista 64 and the mobo I use has had it's lone on board serial port disabled since day one since I use no serial devices. I installed the drivers from IOGEAR's site for 64-bit Vista dated Aug '07, it installed itself to COM4 port then started the LI settings app and no joy, tried all ports actually...nothing with the error below:
sEvent function called.
1 port not opened.
Technical Information
Project : jammer
Dump error of module <WD110COM.DLL> <11.00Ef>.
- WL Call:
Processing <frmmain.btnConnect>, line <24>, thread <0>
Function <sEvent>, syntax # <0>
- Level: fatal error (EL_FATAL)
- Error Code: 100161
- WD55 Error Code: 0
- No system error code
- No system error message
- What happened?
1 port not opened.
- Debug Information:
Fonction (10,148)
- Attached Information:
EIT_DATEHEURE : 09/09/2008 19:53:11
EIT_PILEWL :
Click btnConnect (frmmain.btnConnect), ligne 24
- No identifier in .err
Help
Is the CPU designed to work right out of the box or do we need to set it up first?
Update: Got it fixed, had to reassign a few ports but now reads as below:
ATEN USB to Serial Bridge (COM1)
:beer: