PDA

View Full Version : ZR3 heads



KustomEagle
10-14-2008, 10:55 PM
So i finally got a working control box for my various ZR3 parts... but i think the rear head I have is shot...


Anyone have any spare or old zr3/4 heads sitting around even with bad wires that they'd want to get rid of? :)

lastly anyone know for sure what voltage these heads are supposed to get?

duhtroll
10-15-2008, 08:57 AM
I have two working front heads that I have cut the wires off of. Long story, but I was eventually going to rewire them and use them on a different vehicle. I'm not sure I need them. The plastic on these heads is a bit chewed up due to road wear - pebbles, bugs, etc. but last time I tested them they worked fine.


So i finally got a working control box for my various ZR3 parts... but i think the rear head I have is shot...


Anyone have any spare or old zr3/4 heads sitting around even with bad wires that they'd want to get rid of? :)

lastly anyone know for sure what voltage these heads are supposed to get?

Lucky225
10-15-2008, 02:51 PM
So i finally got a working control box for my various ZR3 parts... but i think the rear head I have is shot...


Anyone have any spare or old zr3/4 heads sitting around even with bad wires that they'd want to get rid of? :)

lastly anyone know for sure what voltage these heads are supposed to get?

I don't think the rear is shot, it's most likely the shoddy wiring, run a tone trace on it I'm sure it's in the wiring.

KustomEagle
10-15-2008, 06:14 PM
I have two working front heads that I have cut the wires off of. Long story, but I was eventually going to rewire them and use them on a different vehicle. I'm not sure I need them. The plastic on these heads is a bit chewed up due to road wear - pebbles, bugs, etc. but last time I tested them they worked fine.

what would I have to do to take ownership of these :)

and lucky it probably is but i've tried and i get no response... i'll remove all the wiring and replace it soon

/edit: anyone know if a front head can be used in place of a rear head on the control box and it not crack out?

duhtroll
10-16-2008, 10:23 AM
Uh, buy me a sammich? Seriously, not looking to get anything out of them. I just have to wait until I can get a jaws of life to get them off the car. Really I just need to get the car on a lift so I can really wrench on the fasteners.

That's what I get for installing them to the bumper with steel washers and machine screws. :o

KustomEagle
10-16-2008, 06:14 PM
Uh, buy me a sammich? Seriously, not looking to get anything out of them. I just have to wait until I can get a jaws of life to get them off the car. Really I just need to get the car on a lift so I can really wrench on the fasteners.

That's what I get for installing them to the bumper with steel washers and machine screws. :o

heh; i'll buy you a sandwich and cover shipping :p