PDA

View Full Version : New LI user - parking sensor question



justin81
12-24-2008, 01:02 PM
I had a dual LI installed yesterday on my Civic. However, I seem to be having some problems with the parking sensor feature. I was just playing with it this morning and drove pretty darn close to a wall (like within a foot or two) and the alarm was not going off. I had just started the car, heard the "welcome" and then started rolling so this was before the 30 second cutoff.

Just how close do you have to be for something to set the sensors off?

The guys at the shop tested it yesterday when one of them stood in front of my car and then walked very close to it. It was going off then.

They also shot the sensors with a TV remote control and the alarm went off and reported an "unknown gun" or some such. I think it's working. I just really want to be sure.

Sorry for the newbie questions.

rockets713
12-24-2008, 01:39 PM
I had a dual LI installed yesterday on my Civic. However, I seem to be having some problems with the parking sensor feature. I was just playing with it this morning and drove pretty darn close to a wall (like within a foot or two) and the alarm was not going off. I had just started the car, heard the "welcome" and then started rolling so this was before the 30 second cutoff.

Just how close do you have to be for something to set the sensors off?

The guys at the shop tested it yesterday when one of them stood in front of my car and then walked very close to it. It was going off then.

They also shot the sensors with a TV remote control and the alarm went off and reported an "unknown gun" or some such. I think it's working. I just really want to be sure.

Sorry for the newbie questions.

Hey is it possible you can post pics of of your LI because i also have a Honda Civic 2007 EX and im just curious were you mounted the heads. Thanks.

ELVATO
12-24-2008, 02:02 PM
They're pointing straight ahead, right? If they're pointing off to the side, not all the reflection will make it back to the sensor, so you need to be closer.

category4
12-24-2008, 02:19 PM
Depends on the color to, dark colors do not work well or at all. Mine typically go off at about 2 feet from the garage wall. You can try putting your hand up to the sensors during the 30 second period to test it.

Laser-InterceptorUSA
12-24-2008, 03:02 PM
I had a dual LI installed yesterday on my Civic. However, I seem to be having some problems with the parking sensor feature. I was just playing with it this morning and drove pretty darn close to a wall (like within a foot or two) and the alarm was not going off. I had just started the car, heard the "welcome" and then started rolling so this was before the 30 second cutoff.

Just how close do you have to be for something to set the sensors off?

The guys at the shop tested it yesterday when one of them stood in front of my car and then walked very close to it. It was going off then.

They also shot the sensors with a TV remote control and the alarm went off and reported an "unknown gun" or some such. I think it's working. I just really want to be sure.

Sorry for the newbie questions.

Hi Justin,

The LI PA settings are programmed at the factory default of minimum sensitivity, about 12 to 18 inches, depending on the reflectivity of the surface and only for the first 15 seconds or so after you hear the "Welcome" Alert and then turn off following the "PA Deactivated" Alert. As the LI is not designed primarily as a Parking Aid, it should not be used as such. As Randy indicated, place your hand within a few inches of the sensor before the PA deactivates to hear the PA indicator beeps. Based on your report, it sounds like the PA as well as the LIDAR Detection functions are operating normally. Additionally, I personally test every LI for proper operation of all it's features before it is shipped.

Cliff - LI-USA

focalcivic
12-24-2008, 03:24 PM
It is rare for it to go off. It took me 3 months to hear the parking sensor warning, and thought there was something wrong when it did finally sound. I thought it was set factory off, then found out later it was set on, but on low.

justin81
12-24-2008, 07:41 PM
Thanks for the advice everyone, Cliff included. I did some more testing and the parking sensor does alert when I put my hand in front of it or if I walk in close proximity. I think I just wasn't driving close enough to the wall. I was being really careful. Don't want to damage my precious heads, lol.

I'll post some pics of the install in a few days once I get my new digital camera up and running. I've got the V1 hardwired now too. I think I'm going to like this ride.:cool:

Laser-InterceptorUSA
12-24-2008, 07:43 PM
We look forward to the PICS!

Merry Christmas and Happy Chanukah! :)

Cliff - LI-USA

TSi+WRX
12-25-2008, 09:54 AM
As the others have said, the parking function should not be relied upon as-such.

This is a jammer, first and foremost, and the parking function is only a thin "legal cover," if you will. ;)

Does it work as a parking-assist device? Yes, it does...

But it is VERY limited, and is based on, as others here have said, the surface reflectivity of the item to the outgoing laser pulses emitted by this unit.

Even Ivan himself - the brains behind this amazing jammer - has said, on the LI Forums, that he would not trust the device as a "blind" parking-assist.

I would only advise using the LI as a parking-assist in "pre-mapped" spots/spaces - i.e. your own tight garage space - where you can furthermore place reflective devices to assist the parking-assist function properly note distance-to-target.

Currently, this inability to function as a true parking-assist device is a fault of *ALL* jammers so-equipped, not just the LI alone.

---

As for the "Unknown Gun" alert, that is completely normal.

Your remote control is sending out an IR pulsetrain that is simply not in the look-up-table of the LI as a "known threat" device. Thus, it reverts to the "Unknown Gun" algorithm.

takeshi
12-26-2008, 05:18 PM
Yup. I've definitely backed into something while trying to use the LI as a parking sensor. I forget what it was but it was not reflective enough (the sensor was definitely working properly).