View Full Version : LI Dual HP vs LI DUAL
What is the difference between the two? Besides the obvious huge cost. Putting on an 05' F150
Just1n
04-28-2009, 07:59 AM
The HP has two diodes in each head versus one diode in the regular dual.
I would say you only need a dual for the F150, considering it's not white or another bright color.
No, it's a burgandy color, chrome bumper, black gill. Dual head setup is what I'm lookng at. Just curious thanks
Stealth Stalker
04-28-2009, 06:32 PM
A regular dual LI should do the job for you. Because of the chrome bumper and front licence plate, you may have to mount the heads a little lower than is optimum, so you *might* end up needing Veil on the headlights. You won't know for sure until you test the set-up against real LIDAR.
An LI HP would give you absolutely JTG performance, and is always recommended if you can afford it. There is no such thing as overkill in the LIDAR game, and it is absolutely the best protection available. But again, I doubt you need that. Laser Shielding your plate and either putting a black bra on your bumper, or painting it with spray-on bedliner would help decrease your LIDAR significantly, assuring that the dual LI, or even a Blinder M45 would do the job just fine.
crazyVOLVOrob
04-28-2009, 07:33 PM
Regular LI dual will do great
YouTube - Nissan Titan Laser Interceptor vs. Laser Atlanta
Donut Patrol
04-28-2009, 09:15 PM
Regular LI dual will do great
YouTube - Nissan Titan Laser Interceptor vs. Laser Atlanta (http://www.youtube.com/watch?v=t-bwwKXPRIA)
I couldn't believe we weren't able to get a PT on that thing..... That's why I laugh when people talk about getting PT's on LI's in real world scenarios.
crazyVOLVOrob
04-28-2009, 09:23 PM
Regular LI dual will do great
YouTube - Nissan Titan Laser Interceptor vs. Laser Atlanta (http://www.youtube.com/watch?v=t-bwwKXPRIA)
I couldn't believe we weren't able to get a PT on that thing..... That's why I laugh when people talk about getting PT's on LI's in real world scenarios.
Chalk that up to a very good installation with the heads mounted properly
Stealth Stalker
04-28-2009, 09:25 PM
Chalk that up to a very good installation with the heads mounted properly
Exactly. Installation is more than half the battle. We could easily get PT on probably most of the LIs on the road because of poor installations. That's why the power of the LI is so important, because few people have optimised installations.
speed-dreams
04-28-2009, 11:33 PM
Chalk that up to a very good installation with the heads mounted properly
Exactly. Installation is more than half the battle. We could easily get PT on probably most of the LIs on the road because of poor installations. That's why the power of the LI is so important, because few people have optimised installations.
Also, some people don't have the chance of test their setups as well :)
Regular LI dual will do great
YouTube - Nissan Titan Laser Interceptor vs. Laser Atlanta (http://www.youtube.com/watch?v=t-bwwKXPRIA)
Isnt that a PL3 in the vid? I dont remember my LA being able to switch the sight to a square :confused:
crazyVOLVOrob
04-29-2009, 10:35 AM
Regular LI dual will do great
YouTube - Nissan Titan Laser Interceptor vs. Laser Atlanta (http://www.youtube.com/watch?v=t-bwwKXPRIA)
Isnt that a PL3 in the vid? I dont remember my LA being able to switch the sight to a square :confused:
yeah the guy has been told but not updated
Donut Patrol
04-29-2009, 11:27 AM
Also, some people don't have the chance of test their setups as well :)
I haven't been able to test mine yet (although I will because I think it is a necessity), but I know my heads are level, and generally pointed in the right direction, so I'm quite confident in my installation. Not to mention I have a relatively small dark frontal area. All I needed after that was one run through a trap at a reasonable speed just to make sure there weren't any faulty heads, etc., and now I have as close to complete confidence as you can get.
speed-dreams
04-29-2009, 12:03 PM
please don,t run into the temptation of doing JTG or making multiple runs...
Also, some people don't have the chance of test their setups as well :)
I haven't been able to test mine yet (although I will because I think it is a necessity), but I know my heads are level, and generally pointed in the right direction, so I'm quite confident in my installation. Not to mention I have a relatively small dark frontal area. All I needed after that was one run through a trap at a reasonable speed just to make sure there weren't any faulty heads, etc., and now I have as close to complete confidence as you can get.
crazyVOLVOrob
04-29-2009, 04:22 PM
please don,t run into the temptation of doing JTG or making multiple runs...
One thins I don't understand by people doing these JTG runs is they are running the speed limit so even if the cop got a speed reading he still wouldn't pull them over:rolleyes:
JTG videos from inside the car prove nothing