PDA

View Full Version : ZR3 Head Angles?



95blklsc
06-21-2009, 08:49 PM
I know I have run across it here before but can't seem to find it.

I'm looking for the angle of the heads. I know the top and bottom half are not parallel and the top with the bubble needs to be level. I eyeballed it when I installed the jammer but I now have a nice compact digital level and would like to be sure they are perfect.

There isn't enough room to get the level on the top surface because they are mounted inverted on the top of the opening of the grill area in my C6 Corvette.

So anyone know the angle of each half from 0 deg? Man it would be so much easier if the heads were perfectly square but that would make molding more difficult.

95blklsc
06-22-2009, 07:08 AM
Well I can always take one off the car and measure the total angle on a flat surface right near the car but I was hoping to avoid some of that hassle.

I know SOMEONE on here knows......:confused: Please!:)

PMoth
06-23-2009, 09:56 AM
D@mn!!! Still no replies huh?
My process would be simple. Use a solid piece of abs plastic that is long enough to secure in the same location where you have the heads mounted now. Place the small level at the end and ensure that the surface is level "before" you mount the heads. Create shims using abs plastic, preferably one solid piece for each head, that provide a level surface and verify with the level. Or mount the heads using adjustable brackets, provided you have the room for them, and temporarily attach the abs plastic to the top of the heads. You now can attach the small bubble level to ensure they are level. I use mini levels as well as blinder cylindrical bubble levels for installs.
This process works well "before" the heads are mounted and secured. I hate to say it 95blklsc but unless someone with a zr3 measures their unit for you, you're going to have to remove the heads if you truly want to verify this yourself. Good luck.

95blklsc
06-25-2009, 06:48 AM
The thing that kills me is I read i ton here before. But after searching a bit I can't find the thread. I'm going to take one off this weekend and measure it. I have a nice very accurate and compact digital level. So I'll post up the angle when I get it. :D