View Full Version : Wireless Bridge
djrams80
03-29-2010, 07:32 PM
Anyone know anything about using a wireless bridge? Which ones to buy? Which ones to avoid? I want to connect my Slingbox to a wireless router two floors above. Will a bridge even work for this application?
Davis
03-29-2010, 10:00 PM
Just find a router with "bridge" mode and set it up as an access point. They make dedicated bridges, but a router should do everything you need in this case.
djrams80
03-29-2010, 10:11 PM
Replacing the router seems like more hassle. There's already a combo router/wireless modem in place, so I just need to wirelessly transmit that signal to two floors below, so that I can run the Slingbox off of a DirecTV box that's seldom used, as opposed to the one that's used most often.
dpatel01
03-30-2010, 01:54 AM
Just find a router with "bridge" mode and set it up as an access point. They make dedicated bridges, but a router should do everything you need in this case.
:dito: and in more cases, cheaper too than a dedicated bridge.
I used to have a Linksys range expander (wre54g?) which was easy to set up but the link was too unstable, no matter how many different settings I tried.
djrams80
03-30-2010, 07:04 AM
Thanks guys. I finally figured out what you are talking about.
http://img403.imageshack.us/img403/2130/belkin.png (http://img403.imageshack.us/i/belkin.png/)
But, then I found this here and these responses seem to suggest that the Belkin router will only work as an access point, if connected to another Belkin router. My router is ald as dirt, which I guess explains why it still has the bridge options.
WikiAnswers - Can you use a Belkin 802.11g router to connect to another wireless network and then share the other wireless network though its own 4 ethernet ports (http://wiki.answers.com/Q/Can_you_use_a_Belkin_802.11g_router_to_connect_to_ another_wireless_network_and_then_share_the_other_ wireless_network_though_its_own_4_ethernet_ports)
kpatz
03-30-2010, 07:21 AM
You wouldn't reconfigure your existing (cable modem/router combo) router as a bridge. You would buy a 2nd router and configure that one as a bridge to your main router, and install it where it can get both your slingbox's signal and your main router's signal.
Davis
03-31-2010, 11:30 AM
You wouldn't reconfigure your existing (cable modem/router combo) router as a bridge. You would buy a 2nd router and configure that one as a bridge to your main router, and install it where it can get both your slingbox's signal and your main router's signal.
That is exactly what you should do.
Lucky225
03-31-2010, 01:46 PM
EWWWWWWWWWWWWWW I hate Belkin. Dj if you want, pay the shipping plus whatever you feel is fair and I can send you a brand new in box NetGear router, it's just sitting on my desk and I have no intention of using it.
swarga
03-31-2010, 02:24 PM
Anyone know anything about using a wireless bridge? Which ones to buy? Which ones to avoid? I want to connect my Slingbox to a wireless router two floors above. Will a bridge even work for this application?
I have heard that it's best if both sides of the bridge are the same make and model of hardware. Apparently there are some incompatibilities between different models, so you might have more trouble making units from two different manufacturers work together.
swarga
03-31-2010, 02:30 PM
You wouldn't reconfigure your existing (cable modem/router combo) router as a bridge. You would buy a 2nd router and configure that one as a bridge to your main router, and install it where it can get both your slingbox's signal and your main router's signal.
No, both ends need to be configured in bridge mode.
Think of the two bridge APs as two ends of an invisible network cable. Whatever WiFi packets going in to one AP are going to come out the other and vice-versa. Some APs might be able to act as a bridge and a regular AP simultaneously, but not all can. DJ may need to dedicate two APs to bridge duty, one for each end.
Pyrofallout
03-31-2010, 03:13 PM
I haven't come across any wireless bridge that doesn't suffer some issues eventually, usually involved falling off the network. They are also a PITA to setup sometimes.
Personally I would suggest against this solution for something like a slingbox which will use lots of bandwidth. If you do go with the wireless bridge option, I would suggest using both a N router and a N bridge. And also make sure all your other wireless devices are also N or that you have a simultaneous dual band router, or the N won't do any good because if a G device connects it will slow all the wireless down to G speeds.
I sure hope your not using a SlingHD either, or you will likely be unhappy with the results either way.
Just my $0.02
OverSteer
03-31-2010, 06:03 PM
I haven't come across any wireless bridge that doesn't suffer some issues eventually, usually involved falling off the network. They are also a PITA to setup sometimes.
Personally I would suggest against this solution for something like a slingbox which will use lots of bandwidth. If you do go with the wireless bridge option, I would suggest using both a N router and a N bridge. And also make sure all your other wireless devices are also N or that you have a simultaneous dual band router, or the N won't do any good because if a G device connects it will slow all the wireless down to G speeds.
I sure hope your not using a SlingHD either, or you will likely be unhappy with the results either way.
Just my $0.02
Ditto
protias
04-01-2010, 10:02 PM
If you can, flash that sucker with DD-WRT.
Pyrofallout
04-02-2010, 08:39 PM
If you can, flash that sucker with DD-WRT.
That too!
swarga
04-03-2010, 12:25 AM
If you can, flash that sucker with DD-WRT.
Excellent choice!
Wireless Bridge - DD-WRT Wiki (http://www.dd-wrt.com/wiki/index.php/Wireless_Bridge)
djrams80
05-03-2010, 05:45 PM
Just to finish this up, I installed a Cisco Wireless Bridge. It cost like $85 at Fry's and works like a champ. I tried to setup my router as an access point and that was a miserable failure. I tried the using the wired bridge through the wall sockets and that was also a miserable failure.
http://images.macnn.com/esta/content/0903/ciscowet610.jpg
http://img217.imageshack.us/img217/2452/slingbox.png (http://img217.imageshack.us/i/slingbox.png/)
AirMoore
05-11-2010, 08:05 PM
Yeah, I go with Linksys products for such applications WHENEVER I CAN.
Some people don't like them... but I have always had good luck with them, if not those, I would go NetGear (just opinion though).
DJ words of wisdom with that... make sure it has AIRFLOW, some people have noted with those style Linksys products they have had some over-heating troubles which can lead them to be hit-or-miss with their operation. They do run a bit hot... (touch it if you don't believe me).
Keep some good airflow... and you should be all good! :thumb2:
ELVATO
05-11-2010, 09:28 PM
I have two Linksys, one as the Inanetz giver (hooked up to the cable modem), and the other hooked up to the 360 in the living room (this one has DDWRT Micro, IIRC). Works fine :)